Did you recognize the culprit in the picture? A comparably inexpensive part of the entire application can cause a lot of problems during operation.

A customer recently approached us because stubborn abrasion was repeatedly causing damage to his agitator.

The original seal struggled to adapt to the operating conditions and always failed again before the planned stop.

ihb Services has offered to design and produce a seal made of different materials so that the customer can drive safely and without interruption from planned stop to planned stop in the future.

It was also recommended to use SKF Speedi Sleeves as a preventive measure to protect against possible wear of the drive shaft surface.

Further documentation available on request
Source: ihb MarCom